|
 |
Tel: (86) 760-22771886
Fax: (86) 760-22772886
Email: sales@steel-mate.com
steelmate@globalsources.com |
|
 |
| |
|
| Home > Tech Support > Parking Assist System |
 |
Parking Assist System |
|
 |
1. After installation, the display doesn't work or no beep.
1) Check if the power supply wire is connected correctly.
2) Check if the ignition is turned to ACC/ON
3) Check if the reverse gear is engaged. (For rear system)
4) Check if all wiring connections are correct.
5) Check if the display/speaker is paired to the ECU (for wireless system)
6) Check if the display/speaker is damaged7) Verify the ground connection
2. Damaged sensor detected.
1) Check if the sensor surface is clean.
2) Check if the sensor is plugged into the ECU properly.
3) Check if the sensor wires are damaged.
4) Check if the sensor is damaged.
3. The obstacle position is not corresponding to the display indicator.
1) Check if the sensors' wires are connected to the ECU in order according to the manual
4. When reverse gear is engaged, the blue digital indicator or the display always indicates
1) Check if there are any obstacles within 0.6 m.
2) Check if there are any sensors mounted too low or detecting the ground
3) Unplug a sensor at a time to check for response.4) Check if the sensors are mounted upside-down
5. Audible voice and warning tones too low.
1) Adjust the volume adjustable switch. (For model with volume adjustable switch)
6. No human voice warnings.
1) Check if the version of this product is with voice warning.
2) Check if the voice warning function is switched on.
7. False alarm
1) Check if all sensors are plugged into the ECU in the correct position tightly.
2) Check the installation height of sensors, and if any sensor detects the ground.
3) Check if the sensor is damaged.
4) Check the installation angle of sensor.
5) Check if the display is damaged.
6) Check if the display matches the ECU
7) Check if the ECU is damaged.
8) Check if the electronic parts or devices in vehicle are interfering with the system.
9) Check if the cables are damaged.
10) Check if the ground wire needs to be connected to car body, or if the connecting point needs to be cleaned and with "0" voltage.
|
|
|
